Search found 4 matches

by PacoG817
Sun Feb 14, 2021 10:36 pm
Forum: Classifieds - Buy, Sell, Trade Used Welding Equipment
Topic: wire feed rollers
Replies: 4
Views: 13984

Re: wire feed rollers

Do you think they would fit the ln-25 wire feed machine?
by PacoG817
Sun Feb 14, 2021 2:32 pm
Forum: Welding Jobs - Industrial Welding Jobs - Pipe Welding Jobs - Tig Welding Jobs
Topic: Welder Writer Required - Remote Work
Replies: 1
Views: 13453

Re: Welder Writer Required - Remote Work

Currently I’m a welder for a pipeline company, I was once new. I remember not being able to put a tack, during my learning process of welding I was also attending night school and am finishing up a degree in quantitative finance. I do not have writing experience due to spending so much time working ...
by PacoG817
Sun Feb 14, 2021 11:35 am
Forum: Metal Cutting
Topic: No Carts Made for Propane Tanks?
Replies: 21
Views: 5903

Re: No Carts Made for Propane Tanks?

Not to my knowledge but what you can do is get a piece of 1/8 by 2 flat bar I believe I cut 41 inches for the propane tanks. Do a bend either cold bend where you work with your clamps or tack and keep bending with torch. Make a perfect circle (keep up with your clamps because the flat bar will not b...
by PacoG817
Sun Feb 14, 2021 11:30 am
Forum: Metal Cutting
Topic: What’s best way to cut expanded metal?
Replies: 20
Views: 8560

Re: What’s best way to cut expanded metal?

With a piece of soapstone mark your lines and go on the part right before the mesh. Cut on the edge of each diamond so when you tack you have roughly 1/8-1/4 inch to weld. With the Metabo grind in a pattern the disc will do all the work and cut your section. Metabo works best I’ve tried them all, no...