Also if your using a fuel powered bevel cutter have someone help you with mastering it or use pipes that have the factory edge and bevel your pipes with a grinder , takes a few minutes but will help for when your in the field with no bevel cutter

When my root is not exactly even and keyhole gets out of control I burn a little ahead of my puddle , adding metal to the landing/bevel area then going back to my keyhole , building the metal up will give you better control

The pamphlet is junk... I'd assume a bad translation. The sharper the tungsten, the tighter the arc. A broad arc will make a broad, shallow bead. A tight arc focuses the heat in a narrow band and it goes deeper. The angle of taper is less critical an heavy stuff, but you still want a point. On thin...

Otto I will have to try that . Also was researching that possibly moisture can get in the tank? I'll find out at school .a friend that welds said to try a a wire gas lense in my nozzle to evenly disperse my gas as he has has a problem with turbulence and problems with the straight nozzle

Haha any correlation with legalization of pot?because if so just go to California man.lots of work in long beach and off shore .heard Bakersfield is having a lot of work.go to Craigslist there is a lot of jobs

Took my tig test and passed two roots and a cover .my last coupon I vent incorrectly so I had failed.so I went to take my test again.i would get splatter when tacking .so I made sure to grind it out nicely and wire wheel everything it was clean.ny partner got the root and machine down to work so I c...

I just passed both those tests.vertical I ran my machine a little cooler as heat rises.i went with a little under a 1/8 root with matching chamfer.make sure you eat that chamfer away so you get consistent penetration and fusion.over head I would go from left to right .aiming my gun into my puddle to...