It's select arc 701-sc .035wire were using a 85/15 mixture argon co2
I read sabb application and yes at my thickness I Dnt need
Preheat plus the temp were we are in Texas is usually 100+degrees
Application is unusual It can weld horizontal.
Easily but this rate and position is puzzling me

Ok sorry guys I'm new to the forum I'm welding 450 1/8 hardox with a linclon intervect 350 At 25'in the air about 45"min downhill it's a dumb bed Body for earth moving ,asphalt ,whatever is Needed but the floor is gotta be wear proof and The walls are 12ga domex or 3mm using 500amp hd Gun with ...

Thanks mike I see I got a few views but no answers
Or even a good guesstimation I guess the application
Is alittle awkward well thanks mike

Thanks fat bob I appreciate that I'm struggling With this welding application if I was welding it Horizontal i would be fine but I'm welding it down Hill you'd think easier right well I'm about 25'in the air And welding @ 45"per min giving me some trouble So any advice would be greatly apprecia...

im wanting to know best setting for welding metalcored wire on 1/8hardox material to 12gauge material at a fast downhill rate and is it the best wire to be using hardox I read was closer to stainless than carbon steel? is that accurate