Page 1 of 1
Pipe Cutting to match another pipe?
Posted: Fri Mar 21, 2014 8:50 pm
by Greg From K/W
Jody had a site to make a template to cut the end of a pipe so it matched at a joint. Anyone have that site? Can you post it and sticky it in a useful tips thread or something?
Re: Pipe Cutting to match another pipe?
Posted: Fri Mar 21, 2014 9:06 pm
by Braehill
Not sure if this is the same one but here is one I had book marked.
Len
http://metalgeek.com/static/cope.pcgi
Re: Pipe Cutting to match another pipe?
Posted: Fri Mar 21, 2014 9:28 pm
by Greg From K/W
Ya thats it thanks.