[POgli]

Hi,

I a beginner, just finished my first argon bottle and when I replaced it, reconnected everything, I realized that the flow wasn't going any higher than 3 lpm.
After some debugging, I verified that the flow spikes once I shut the cylinder valve down, topping up the flowmeter until there isn't any pressure in the regulator.

The cylinder pressure is at 2650 psi.

I posted a video to better explain: bYmkU2kbixU

How do I fix this?

Thank you

[VA-Sawyer]

Are you doing that with no hose attached to the flowmeter? Perhaps it is tripping a max flow limiter in the regulator.
If it still does that when connected to the welder, then I would say something is wrong with the regulator.

[tweake]

i suspect its the tank pressure shutting the regulator valve. quite possible it got a bit of dirt in it on the change over.
or its just a junk regulator which is not uncommon with cheap welders.

[Spartan]

I would think the valve on the HP side is not seating or actuating properly. Many things could cause this. Take a wrench and lightly tap several times around the sides of the body of the HP side in the middle of the reg. It's a shot in the dark, but that can sometimes help to re-seat a catawampus component. If that fails, plan to buy a new reg. A higher quality one. I've found that trying to otherwise disassemble and "fix" faulty regs is a waste of both time and money.

[POgli]

Hi,

Following your suggestions, I de-attached the flowmeter and found gunk similar to dry honey in there. Cleaned it up, and now it flows perfectly.

Gunk in the whole

IMG_4868.JPG (43.5 KiB) Viewed 901 times

It works

IMG_4872.JPG (47.34 KiB) Viewed 901 times

Thank you very much.

[tweake]

good to see its sorted.
looks like its got that crappy sealant cheap nasty crowds use. i usually see that stuff on the budget air compressors.