O/A on steel tubing
Posted: Sun Jan 08, 2012 9:30 pm
I need some opinions.
Would you trust o/a welds on cold rolled 1.25" x .125" mild steel dom tubing for a motorcycle frame?
Think warping would be too big of an issue? Could it be avoided by allowing enough time to cool between 1/4 section welds?
Ideas, suggestions, precautions, criticisms, all welcome.
If you could point me in the direction of some good o/a welding info, it would also be appreciated.
Never can get enough.
Would you trust o/a welds on cold rolled 1.25" x .125" mild steel dom tubing for a motorcycle frame?
Think warping would be too big of an issue? Could it be avoided by allowing enough time to cool between 1/4 section welds?
Ideas, suggestions, precautions, criticisms, all welcome.
If you could point me in the direction of some good o/a welding info, it would also be appreciated.
Never can get enough.