Page 1 of 1

Welding table

Posted: Wed Feb 27, 2013 5:11 pm
by NYWELDERJim
Can anyone tell me the brand of welding table used in many of Jody's videos? My machine shop operation has an ancient welding table which offers NO versatility and takes a long time to setup for anything even slightly complex. I have seen how fast and easy it is to fixture parts on the table Jody uses.

Does anyone have suggestions on other brands of welding tables?

Thanks!

Jim

Re: Welding table

Posted: Wed Feb 27, 2013 5:40 pm
by KP161

Re: Welding table

Posted: Wed Feb 27, 2013 6:24 pm
by weldin mike 27
Hey,

Go to the above link, it is called the Build pro table. There are a few different sizes.

As for other brands, Google Fabrication Tables and see what pops up.

Mick

Re: Welding table

Posted: Wed Feb 27, 2013 9:46 pm
by NYWELDERJim
Thank you very much! I visited the Build Pro website, it shows some awesome products! Lot's of fixturing, clamps, guides. I am going to get in contact with a dealer in my area and see what the prices are for the various options.

Best regards,

Jim

Re: Welding table

Posted: Thu Feb 28, 2013 7:00 am
by weldin mike 27
Hey,

Pleasure, while you are talking to them, my address is..... :D

mick

Re: Welding table

Posted: Thu Feb 28, 2013 10:51 am
by Mike
nice stuff but not cheep.

Re: Welding table

Posted: Thu Feb 28, 2013 8:43 pm
by NYWELDERJim
Their system looks to be available in sections or modules. I am looking at getting a basic table and some fixturing then adding to it as I can afford it. A little at a time.

Jim

Re: Welding table

Posted: Fri Mar 01, 2013 6:56 am
by weldin mike 27
Hey,

I was looking through the WT& T page and found some strong hand vids,

http://www.weldingtipsandtricks.com/wel ... video.html

http://www.weldingtipsandtricks.com/str ... lding.html

Mick

Re: Welding table

Posted: Thu Mar 07, 2013 7:50 pm
by watermelon
summitracing.com sells these tables and fixtures too

Re: Welding table

Posted: Thu Mar 07, 2013 7:57 pm
by Otto Nobedder
There was a topic here, under "projects", I think, where a fellow build his own, and did an incredible job on the cheap!

Any of the regulars (Mick?) remember where that was? I'll have a hunt, or maybe the OP will read this thread?

Steve S

Re: Welding table

Posted: Fri Mar 08, 2013 4:06 am
by weldin mike 27
Hey,

Here it is. Man i love this site( translate to ......i spend too much time here.)

http://forum.weldingtipsandtricks.com/v ... 2252#p9579

Mick