[gamble]

Where can I get a clamp like this?
http://www.summitracing.com/parts/vtr-ug125-c3
BUT with the vpad on the other side? I need something like this to secure an oddball pipe to my chop saw

[exnailpounder]

If it was me, I would buy that clamp and cut the ends off, swap them around and reweld it to what I need. It looks like it would be easy enough. Just my 2cts

[gamble]

If it was me, I would buy that clamp and cut the ends off, swap them around and reweld it to what I need. It looks like it would be easy enough. Just my 2cts

it's not a bad idea and i have thought about it, but welding too close to a magnet will crack them.

[exnailpounder]

TIG welding too close to a magnet will cause arc wander but I never heard of a a magnet causing a weld to crack.

[weldin mike 27]

https://www.arc-zone.com/index.php?main ... ts_id=9771 this one with the round bit is designed to slip over the toggle pad of the clamp. A little tig tack should be sufficient to hold it.

[dirtmidget33]

https://www.arc-zone.com/index.php?main ... ts_id=9771 this one with the round bit is designed to slip over the toggle pad of the clamp. A little tig tack should be sufficient to hold it.

They got those pads that screw on to top pads also. You need to have the heavy-duty top pads

http://www.stronghandtools.com/strongha ... pvpads.php

This link show what heavy-duty top pads look like http://www.stronghandtools.com/strongha ... hdpads.php

[gamble]

https://www.arc-zone.com/index.php?main ... ts_id=9771 this one with the round bit is designed to slip over the toggle pad of the clamp. A little tig tack should be sufficient to hold it.

excellent, that's what i need. Thank you

[weldin mike 27]

Sweet as.