Comments & questions on new & past videos
Mig basics part 7 vertical uphill multipass tee
Post Reply
User avatar

What is your technique and what are your settings for uphill mig welding?
This was done using 19.5volts and 245 ipm using .035 er70s6. I think that Increasing my wire a bit or slightly lowering voltage would have probably reduced spatter a bit but this thermal arc 252i is pretty finicky.
Best to everyone,
Jody
JycdRwDLg58
Top
User avatar
  • Posts:
  • Joined:
    Wed Oct 23, 2013 3:30 pm
  • Location:
    Palmer AK

Jonathan is famous!!
Image
Image
Just a couple welders and a couple of big hammers and torches.

Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Top
User avatar
  • Posts:
  • Joined:
    Thu Jan 24, 2013 10:13 pm
  • Location:
    Eddy, TX

I don't know about famous but I do appreciate Jody mentioning me. Not sure if I a worthy of it though.

As for my vertical up technique, I mostly use the "Z" method. I have tried the other methods Jody shows and they work well but as a personal preference I like the "Z". My favorite settings for a very pretty weld is around 19.7 volts and 220 ipm on my Millermatic 252. When a tight weave is held it comes out very pretty, in my opinion.
-Jonathan
Top
Post Reply

Return to “Video Discussion”