Please can you do a video on Tig welding of copper to copper and brass to brass
Thks
Copper and brass is quite forward to weld - Do you have some specific problems doing that?
This is a welded windmill-tip, i've produced alot of those.
This is a welded windmill-tip, i've produced alot of those.
Migatronic Automig 233 MPS
Migatronic Sigma² 400 Pulse CW
Migatronic Pilot 2400 HP
Migatronic Sigma² 400 Pulse CW
Migatronic Pilot 2400 HP
ajlskater1
- ajlskater1
-
Ace
-
Posts:
-
Joined:Thu Feb 02, 2012 5:32 am
Jody does have one video were he does a repair on brass.
chopper3421
- chopper3421
-
New Member
-
Posts:
-
Joined:Sun Aug 04, 2013 4:59 pm
-
Location:Fort Lauderdale
Hey, new here, first post. Sorry, I did not think you could tig weld brass because of the zinc content. Is it possible?
ajlskater1
- ajlskater1
-
Ace
-
Posts:
-
Joined:Thu Feb 02, 2012 5:32 am
Yes you can tig brass. You need to wear a respirator. It does suck to weld cause it does have a tendency to pop on to your tungsten if you get of to hot. At least that's my experience with it.