Page 1 of 1
Tig welding of copper to copper and brass to brass
Posted: Thu Apr 04, 2013 1:30 pm
by davestewart53
Please can you do a video on Tig welding of copper to copper and brass to brass
Thks
Re: Tig welding of copper to copper and brass to brass
Posted: Sun Apr 07, 2013 5:30 am
by Citroën
Copper and brass is quite forward to weld - Do you have some specific problems doing that?
This is a welded windmill-tip, i've produced alot of those.
Re: Tig welding of copper to copper and brass to brass
Posted: Sun Aug 04, 2013 2:39 pm
by ajlskater1
Jody does have one video were he does a repair on brass.
Re: Tig welding of copper to copper and brass to brass
Posted: Sun Aug 04, 2013 5:38 pm
by chopper3421
Hey, new here, first post. Sorry, I did not think you could tig weld brass because of the zinc content. Is it possible?
Re: Tig welding of copper to copper and brass to brass
Posted: Sun Aug 04, 2013 6:50 pm
by ajlskater1
Yes you can tig brass. You need to wear a respirator. It does suck to weld cause it does have a tendency to pop on to your tungsten if you get of to hot. At least that's my experience with it.