Sent from my iPhone using Tapatalk
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
Welcome, Scott,
You'll note I moved your post to the "classifieds" section, and left the shadow topic in the TIG forum.
We usually don't approve a "first post" that's selling something, but this is clearly yours. You'll get a better response from the membership here if you'll take a moment to say, "Hello," in the "Member Introduction" sub-forum. This is a great community, and I hope you have more interest in us than selling a sharpener.
Steve S
You'll note I moved your post to the "classifieds" section, and left the shadow topic in the TIG forum.
We usually don't approve a "first post" that's selling something, but this is clearly yours. You'll get a better response from the membership here if you'll take a moment to say, "Hello," in the "Member Introduction" sub-forum. This is a great community, and I hope you have more interest in us than selling a sharpener.
Steve S
Scott Mann
- Scott Mann
-
New Member
-
Posts:
-
Joined:Sun Aug 28, 2016 12:02 am
Will do Otto thanks.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
John Chamorro
- John Chamorro
-
Guide
-
Posts:
-
Joined:Thu Mar 19, 2015 9:44 am
-
Location:San Antonio Valley Peoples Republic of Californy
can you adjust the length of the taper for needle point for stainless or is the angle set?
I don't know it all but I'm working on it.
