FS: used Eastwood Versacut 40A dual-voltage plasma cutter
Posted: Mon Jan 21, 2019 9:13 pm
Time to let this go. It's been pretty good to me for over 5 years. Still works great. HF start can be finnicky but usually I attribute it to having a crappy ground connection. I always had to make sure it had a very good ground or otherwise the HF start just wouldn't. Rated to cut 3/8", and it will, but leaves a lot of slag. 1/4" is where the clean cutting stops at. Will severance cut 1/2" not too badly. Give it 110psi of clean dry air and watch out for those sparks!
Package includes:
Oh, and it works just fine on a 7kW generator, but it's even more picky about ground cleanliness. So long as you keep the arc length within 1/16", it will work just fine.
Package includes:
- Qty:1, Eastwood Versacut 40A dual-voltage plasma cutter
- Qty:1, Ground clamp with longer cable
- Qty:1, plasma torch
- Qty:1, 6-50R to 5-15P adapter for use on 120V
- Qty:14, long electrodes (for use with the long pipe tips)
- Qty:18, long pipe tips
- Qty:17, standard electrodes
- Qty:7, short pipe tips
- Qty:1, standard tip
- Qty:8, diffusers
- Qty:2, cups
Oh, and it works just fine on a 7kW generator, but it's even more picky about ground cleanliness. So long as you keep the arc length within 1/16", it will work just fine.