Hey all,
I'm hobbyist type welder with a lot of interest in getting skilled enough with TIG (mild steel and stainless) so I can make safe and good looking welds.
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
Welcome, grinder,
You've found a good spot for help with your goal. I like that you put "safe" before "good looking". They're not necessarily the same thing. I've seen many welds that were one but not the other (and a handfull that were neither
).
We're all about sharing knowledge and experience, and there's a broad base of it here.
Steve S
You've found a good spot for help with your goal. I like that you put "safe" before "good looking". They're not necessarily the same thing. I've seen many welds that were one but not the other (and a handfull that were neither
).We're all about sharing knowledge and experience, and there's a broad base of it here.
Steve S
Hello. Just wanted to introduce myself because I am a noo here too.. Tell me about what you fabricate or weld in general. Always interested in what other people may know that I may not. And also always willing to share what works fo me.
If you spit on it and it sizzles don't pick it up bare handed.
^o^
^o^
- AKweldshop
-
Weldmonger
-
Posts:
-
Joined:Wed Oct 23, 2013 3:30 pm
-
Location:Palmer AK
Welcome to the forum grinder 
Just a couple welders and a couple of big hammers and torches.
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024