Page 1 of 1
Hello from Washington State
Posted: Fri Sep 06, 2019 10:58 am
by PCR60
Just a short intro... I’m not a certified welder but I do a bit of welding at work (Public Works). We have professional welders where I work and have learned a ton from them. I enjoy working with steel and a huge hobby of mine is knife making. I’d like to start doing some “art” welding also. Any input (equipment-wise) for artwork would be appreciated. I’m competent in GMAW and hope to learn TIG at some point. Anyway, I’m glad to be here!
Re: Hello from Washington State
Posted: Sat Sep 07, 2019 5:34 am
by BillE.Dee
Welcome from Pennsylvania. I'm sure you'll have a great time and experience.
Bill
Re: Hello from Washington State
Posted: Sat Sep 07, 2019 9:54 am
by Radishfever
Hi from Cape Cod,
You are not the only one. There are several of us learning. Check the project section for ideas and maybe post some of the work you have done. More pictures the better.
Be more specific about what equipment you mean. There are all kinds of equipment in the shop.
Re: Hello from Washington State
Posted: Mon Sep 09, 2019 10:04 pm
by PCR60
BillE.Dee wrote:Welcome from Pennsylvania. I'm sure you'll have a great time and experience.
Bill
Thank you! I lived in Bradford Co. many years ago.
Re: Hello from Washington State
Posted: Mon Sep 09, 2019 10:06 pm
by PCR60
Radishfever wrote:Hi from Cape Cod,
You are not the only one. There are several of us learning. Check the project section for ideas and maybe post some of the work you have done. More pictures the better.
Be more specific about what equipment you mean. There are all kinds of equipment in the shop.
Thanks, and will do.