intro from NZ
Posted: Sun Jan 03, 2021 6:23 am
Hi folks,
saying Hi. Im a fabricator from new Zealand, about to complete my trade, right as Im moving into management, so Im in between trade and hobbyist I guess, as I have a small workshop and most of my welding and Fab work is on personal projects.
Im a welder / machinist / fab / whatever kind of bloke.
I have been following a few channels on YT for a while including WT&T, TOT, Blondihacks, 6061, as these tend to cover my preferences in an informative and engaging way.
Ive been in and out of fab / light engineering for probably 15 years, but an in no way a expert, so I loo forward to getting answers to some dopey questions, as well as contributing in areas where I have something to offer.
Looking forward to being part of this community, cheers!
-Tim
saying Hi. Im a fabricator from new Zealand, about to complete my trade, right as Im moving into management, so Im in between trade and hobbyist I guess, as I have a small workshop and most of my welding and Fab work is on personal projects.
Im a welder / machinist / fab / whatever kind of bloke.
I have been following a few channels on YT for a while including WT&T, TOT, Blondihacks, 6061, as these tend to cover my preferences in an informative and engaging way.
Ive been in and out of fab / light engineering for probably 15 years, but an in no way a expert, so I loo forward to getting answers to some dopey questions, as well as contributing in areas where I have something to offer.
Looking forward to being part of this community, cheers!
-Tim