Introduction
Posted: Sun Aug 08, 2021 9:24 am
Hello from Australia. Certified Metal in Gap specialist.
Wand waving Harry potter level - check
Solid core- check
Flux core- double check
Tig- crap to acceptable quality.....maybe.
Been in industry well over a decade, I have done lots of Structural, mining, pumps, architectural, etc etc.
and have enjoyed it all. Feeling the need to push into a different area, so remembered my crap tig ability and started looking at lifting my game a level, or more
I go alright tig verti up on sched pipe or plate, outside corners go smoothly too, am shockingly inept at a basic fillet on ally. like anything you are an average of those you choose to hang out with so am really positive about learning heaps in this space. Any help or advice with staino or aluminium appreciated, mig or tig.
Cheers.
Wand waving Harry potter level - check
Solid core- check
Flux core- double check
Tig- crap to acceptable quality.....maybe.
Been in industry well over a decade, I have done lots of Structural, mining, pumps, architectural, etc etc.
and have enjoyed it all. Feeling the need to push into a different area, so remembered my crap tig ability and started looking at lifting my game a level, or more
I go alright tig verti up on sched pipe or plate, outside corners go smoothly too, am shockingly inept at a basic fillet on ally. like anything you are an average of those you choose to hang out with so am really positive about learning heaps in this space. Any help or advice with staino or aluminium appreciated, mig or tig.
Cheers.