Page 1 of 1
New Member - looking for some TIG advice
Posted: Sat Feb 14, 2015 10:19 pm
by Curt
Very interested in the MIG like TIG debate. Also getting into TIG on sheetmetal and also stainless tube .049 wall 304.
Re: New Member - looking for some TIG advice
Posted: Sun Feb 15, 2015 2:19 am
by xwrench
Welcome to the forum, Curt.
Re: New Member - looking for some TIG advice
Posted: Sun Feb 15, 2015 2:56 am
by steeldr.
What is your question?
Re: New Member - looking for some TIG advice
Posted: Sun Feb 15, 2015 8:53 am
by Mike
Welcome to the forum Curt.