I made the cardboard mock-up to layout the dimensional items and also to build a template for a hand plasma cutter. As soon as I have the bugs worked out I'll share the information and template file. The legs I'm going to figure out using several ideals. A sheet 1/8 inch steel plate and a rebar post type stand as just a couple. Any thought please toss them my way.
Bumblebee
- Bumblebee
-
New Member
-
Posts:
-
Joined:Sat Sep 17, 2016 11:39 pm
-
Location:Myrtle Beach SC
An ideal from one of Jody video;s. I got the basic ideal from a YouTube Video but they played it real close to the vest sharing any working information for dimensions etc. So as Fred Flintstones would say I'm slightly smarter than the average bear. I made the cardboard mock-up to layout the dimensional items and also to build a template for a hand plasma cutter. As soon as I have the bugs worked out I'll share the information and template file. The legs I'm going to figure out using several ideals. A sheet 1/8 inch steel plate and a rebar post type stand as just a couple. Any thought please toss them my way.
I made the cardboard mock-up to layout the dimensional items and also to build a template for a hand plasma cutter. As soon as I have the bugs worked out I'll share the information and template file. The legs I'm going to figure out using several ideals. A sheet 1/8 inch steel plate and a rebar post type stand as just a couple. Any thought please toss them my way.- Attachments
-
- Fire Pit Rear Card board mockup.JPG (52.71 KiB) Viewed 485 times
-
- Fire Pit Cardboard Setup.JPG (49.42 KiB) Viewed 485 times
- MosquitoMoto
-
Weldmonger
-
Posts:
-
Joined:Sat Aug 01, 2015 8:38 am
-
Location:The Land Down Under
Cool - looking forward to seeing this in steel!
Kym
Kym