[Farmwelding]

Anyone have any tips for cutting about 11 gauge steel with oxy-fuel rig. More specifically circles.

[Poland308]

Keep your torch tip clean and move fast. What size cutting tip and what are your pressures on the gauges as the gas is flowing?

[Farmwelding]

Not sure in tip size but on first I was at 40 oxygen and 5 acetylene and then down 16 and 2.

[Poland308]

Tip size is critical on thin stuff if you want a clean cut. I don't have a copy on hand but I'll see if I can find one for proper sizing of the tips based on cutting thickness and tank size.

[Poland308]

http://training.victortechnologies.com/ ... sset_id=61

Edit: http://victortechnologies.com/IM_Upload ... ul2011.pdf
Found it

[noddybrian]

Conventionally we used sheet nozzles for this - these are rather directional though as the heating flame & cutting jet are behind each other - can cut circles with care if the diameter is not too small - they do leave a very nice cut & very small kurf.

sheet nozzle.png (50.9 KiB) Viewed 743 times