Welding Tips and Tricks

Looking for a good design to make a circle cutter for an oxy cutting head that is rigid and holds the radius without slipping horizontally of vertically
please submit some ideas below!

Hey,
welcome to the forum, Please drop by the members introduction area and introduce yourself first.


Mick

http://www.youtube.com/watch?v=4ad3obmk9SY

pigdog wrote:Looking for a good design to make a circle cutter for an oxy cutting head that is rigid and holds the radius without slipping horizontally of vertically
please submit some ideas below!

WerkSpace wrote:http://www.youtube.com/watch?v=4ad3obmk9SY

pigdog wrote:Looking for a good design to make a circle cutter for an oxy cutting head that is rigid and holds the radius without slipping horizontally of vertically
please submit some ideas below!

Holy cow! Do you think he has done that before? I bet he could do that and tell you a pretty good yarn at the same time. Nice link, thanks!

WerkSpace wrote:http://www.youtube.com/watch?v=4ad3obmk9SY

pigdog wrote:Looking for a good design to make a circle cutter for an oxy cutting head that is rigid and holds the radius without slipping horizontally of vertically
please submit some ideas below!

@ WerkSpace

Thanks for sharing the YouTube link man, that Oxy-ace circle cutter looks so cool.
Got to make one for myself, very simple in design yet very useful and practical !!!

Hey,

Here is another one.

I added it to the Forum facebook page.

Mick

Hey Mick, thanks for the link but when I clicked it, the contents are already un available, sad to say.