Page 1 of 1
Pipe Cutting to match another pipe?
Posted: Fri Mar 21, 2014 8:50 pm
by Greg From K/W
Jody had a site to make a template to cut the end of a pipe so it matched at a joint. Anyone have that site? Can you post it and sticky it in a useful tips thread or something?
Re: Pipe Cutting to match another pipe?
Posted: Fri Mar 21, 2014 9:06 pm
by Braehill
Not sure if this is the same one but here is one I had book marked.
Len
http://metalgeek.com/static/cope.pcgi
Re: Pipe Cutting to match another pipe?
Posted: Fri Mar 21, 2014 9:28 pm
by Greg From K/W
Ya thats it thanks.
Re: Pipe Cutting to match another pipe?
Posted: Sat Mar 22, 2014 12:40 pm
by Otto Nobedder
Greg, Len,
I made copy of this topic in "welding information".
I think I'll ask the webmaster to rename that subforum "Welding library", so it's purpose is more obvious. That way, there's a place to look for books, articles, wesites, programs, and apps without having to search the whole site and all the videos.
Steve S
Re: Pipe Cutting to match another pipe?
Posted: Sat Mar 22, 2014 9:48 pm
by Greg From K/W
Thats a great idea. There is a lot of info and sites that are shared. I find that info like that gets lost in the piles after a while. Nast z28.com does that with all the little tutorials and site tips they get. I have asked them to put that site in their tips area as well as Jody's video it came off.