Welding Tips and Tricks

Posted: **Mon Jan 13, 2014 9:59 pm**

Looking for practical tips / advice for taking AWS D1.5 using GMAW

3G and 4G positions

Coupon 1" thick x 7" long. 22.5 degree bevel each side, 45 degree opening with a 1/8 gap, 3/8" backing bar x 3"

1/16" flux wire with 100% CO2

285 ipm at 26.5 volts using a LN-25 PRO Dual Power feeder

Both 3g and 4g coupons will be X -Rayed

Any Advice?

Joseph

Posted: **Mon Jan 13, 2014 10:06 pm**

Yes, hello to you, too!

Thanks for the introduction...

I'm moving your topic to the "certifications" category, where that topic is discussed.

Steve S

Posted: **Mon Jan 13, 2014 10:10 pm**

We are a network of friends, here.

If you wish to be in a network of friends, who share and help each other, then, welcome!

If you just want to show up and throw a question in the wind....

Steve S

Posted: **Tue Jan 14, 2014 6:51 am**

Like button,.....

Posted: **Tue Jan 14, 2014 10:30 am**

Welcome to the forum Joseph.

Posted: **Tue Jan 14, 2014 1:37 pm**

Welcome Joseph
Glad you decided to pull in

John

Posted: **Sat Feb 08, 2014 11:31 am**

Joseph,
How did your test turn out?

Welding Tips and Tricks

AWS D1.5 Certification

AWS D1.5 Certification

Re: AWS D1.5 Certification

Re: AWS D1.5 Certification

Re: AWS D1.5 Certification

Re: AWS D1.5 Certification

Re: AWS D1.5 Certification

Re: AWS D1.5 Certification