![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
Tonight I figured out what the problem was, as it turns out the Chinese Dinse 35 has a plastic bezel on it that protrudes out farther, preventing the Lenco from fitting in properly. I used some dykem to figure out the misfit, and to solve the problem I used a small homemade 1" belt sander to take off some of the handle front, allowing the Dinse connector to insert far enough to twist.
I've been using this clamp for a while, it's a great clamp. I used a hydraulic crimper to put a lug on the clamp end and some heat shrink around it. Glad to get the Lenco Dinse on there finally.
Everything is a problem on the green weenie, when I bought a CK torch I had to rotate the Dinse fitting for the torch so that the gas hose could plug in...
![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
Lincoln 300 amp clamp
https://www.amazon.com/LINCOLN-ELECTRIC ... 326&sr=8-2
No 2 welding cable, when I bought this it was $1.15/ft, it's gone in the past year, I used 25', now it's $1.60/ft.
https://www.ebay.com/itm/WELDING-CABLE- ... 2749.l2649
Sanding on 1" homemade belt sander: After sanding handle back: Lincoln 300 amp clamp: Perfect fit with Lenco Dinse 35: