Stick Welding Tips, Certification tests, machines, projects
4th run at pipe
Post Reply
One1
  • One1
  • Active Member
    Active Member
  • Posts:
  • Joined:
    Wed Nov 22, 2017 2:41 pm
  • Location:
    Chattanooga TN

86445A8A-8111-4992-B53F-91B2B2F181B3.jpeg
86445A8A-8111-4992-B53F-91B2B2F181B3.jpeg (45.77 KiB) Viewed 674 times
C024ACC9-A288-4F51-8739-0AC0DA30F019.jpeg
C024ACC9-A288-4F51-8739-0AC0DA30F019.jpeg (66.8 KiB) Viewed 674 times
38064872-C01A-4D13-87DA-8A8F1E7FBB2A.jpeg
38064872-C01A-4D13-87DA-8A8F1E7FBB2A.jpeg (54.32 KiB) Viewed 674 times
58C5478D-839F-4E62-9BDB-C3E5B1FFF10D.jpeg
58C5478D-839F-4E62-9BDB-C3E5B1FFF10D.jpeg (48.23 KiB) Viewed 674 times
How is the height on this? I’ve only tried pipe a couple times and i typically come around to it once every few months when i have 30 mins to prep pipe. I’m not striving for perfection with no experience at it, but how far off acceptable is it? Undercut is free of charge. I was waaayyyy to busy trying to rotate to bother worrying about that yet.
1957 Lincoln Idealarc 300, Miller 211 v1 mig, Lincoln 3350, CK Worldwide CK17FV, 9FV
Top
Poland308
  • Posts:
  • Joined:
    Thu Sep 10, 2015 8:45 pm
  • Location:
    Iowa

Looks ok. Typical WPS I’ve seen is no more than 3/32 for positive reinforcement.
I have more questions than answers

Josh
Top
snoeproe
  • Posts:
  • Joined:
    Sat Dec 09, 2017 11:37 am

1st photo shows some light undercut on the toes. Need to get rid of that. Might want to run 2 smaller stringers instead of that one larger bead for a cap. Either that, or weaving your cap while holding the edges, if your allowed to.
Top
Post Reply

Return to “Stick Welding/Arc Welding - Shielded Metal Arc Welding”