Just want some feedback on how one of my vertical plates looks, I'm still in school but getting ready to test for a shipyard
- Attachments
-
- 20151104_122303.jpg (33.87 KiB) Viewed 2284 times
Last edited by Csaw on Sun Nov 08, 2015 6:31 pm, edited 1 time in total.
Welcome Csaw, hope you do well at the shipyard.
I'm going to move your topic over to the stick/arc welding category where you will get more views and plenty of comments I'm sure.
I'm going to move your topic over to the stick/arc welding category where you will get more views and plenty of comments I'm sure.
Go break something, then you can weld it back the right way.
First off how did your test go? Second I recommend putting a little weave motion or upside down U motion to your beads. it helps me to keep in time and the weld tends to come out a little flatter without the hump in the middle like yours did here.