[Maloney1220]

20170120_113236.jpg (51.08 KiB) Viewed 1133 times

6010 open butt uphill 7018 fill and cap... SOB.. lol
GD root.. I'll keep at it fellas and ladies!

[Poland308]

Patience And practice is always the key to that test! I have failed it once and passed it twice on pipe.

[PeteM]

Thats what they're for! Better now than for a job.

[weldin mike 27]

Also, round the edges off the the coupons before bending. The sharp edges can lead to a stress failure (not what you have here)

[Poland308]

Like Mike said! And I usually polish it with a flapper wheel while keeping the grinding marks going in the direction of the bend not crosswise.

[ryanjames170]

Like Mike said! And I usually polish it with a flapper wheel while keeping the grinding marks going in the direction of the bend not crosswise.

ill second that one..

[weldin mike 27]

I din't realise they were going along the weld. Yep, always grind at 90 degrees to the weld. ( a good rule in everything, not just tests)

[Maloney1220]

Thanks for the imput!!! Im giving it hell.