Page 1 of 1

Mini-Weld 130

Posted: Thu Sep 21, 2017 10:47 am
by gabyh

Re: Mini-Weld 130

Posted: Thu Sep 21, 2017 4:02 pm
by Artie F. Emm
Welcome to the forum. I did a quick check but didn't find anything about make and model. Does it weld?

Re: Mini-Weld 130

Posted: Thu Sep 21, 2017 6:19 pm
by gabyh
it's seem like a inverter maybe produced in italy but i don't known who is EWS company/manufacture

Re: Mini-Weld 130

Posted: Fri Sep 22, 2017 12:48 am
by Artie F. Emm
Agreed, an inverter with DC output based on the marks on the electrical plate.

How did you come to have it, and does it have cables with fittings to weld? One will be a ground clamp and the other holds the electrode.

Re: Mini-Weld 130

Posted: Fri Sep 22, 2017 5:39 am
by gabyh
another foto
http://www.tehnium-azi.ro/uploads/month ... 074758.jpg
http://www.tehnium-azi.ro/uploads/month ... 212631.jpg
http://www.tehnium-azi.ro/uploads/month ... 212653.jpg
use irfp 450 and mur diode/rectifier
what tipe of potentiometer i can use because i lost him ...original it's a potentiometer with hole in the midle..2.2ko

Re: Mini-Weld 130

Posted: Fri Sep 22, 2017 7:30 am
by Artie F. Emm
Ok, sounds like your machine needs a potentiometer.

If you'll google "2.2k potentiometer" you can view images to see which one is closest to the one you remember- there are several with holes.

Good luck- let us know how it goes!

Re: Mini-Weld 130

Posted: Sun Sep 24, 2017 4:14 am
by gabyh
problem it's not potentiometer ...connection of potentiometer pins is problem ...on the pcb

Re: Mini-Weld 130

Posted: Sun Sep 24, 2017 9:07 pm
by Otto Nobedder
gabyh wrote:problem it's not potentiometer ...connection of potentiometer pins is problem ...on the pcb
So, cold solder joint?

A common flaw. A simple re-melt with a fully hot and properly tinned 35W soldering iron should have you up and going.

Adding a tiny dab of some fine rosin-core solder is never a bad idea, as there may be oxides inside the failed joint.

Re: Mini-Weld 130

Posted: Mon Sep 25, 2017 7:30 am
by gabyh
i repeat ..problem is ...i don't known which is the pinout on pcb for this potentiometer