Page 1 of 1
Xuper NucleoTec 2222N
Posted: Sun Dec 30, 2018 3:48 am
by Paymaker
Fixing a crack in an extruder casing over head! Is this the wrong rod to weld overhead with! I’m having a heck of a time with this rod!
Sent from my iPhone using Tapatalk
Re: Xuper NucleoTec 2222N
Posted: Sun Dec 30, 2018 11:40 am
by Poland308
Description from the manufacturer pdf says travel in an upward progression. That indicated to me it is an all position rod. It’s high nickel rod so it may be that it just welds very different from what your used to. I would recommend stringers only no side to side weave.
Re: Xuper NucleoTec 2222N
Posted: Sun Dec 30, 2018 4:19 pm
by E T
http://www.ceweld.nl/en/node/1970
according to the above link those rods are not suitable for overhead.
Eric
Re: Xuper NucleoTec 2222N
Posted: Thu Jan 03, 2019 12:07 am
by Poland308
That’s a much more descriptive link than the one I found! It shows vertical up but not overhead.