I did a lot of firsts on this job. One of my first aluminum tig jobs. Welded 1/16” to 1/8” and used roll pins. I also decided building doors is a pain!! Building them, not so bad. Installation is another story. Old construction so everything is off a bit and just tightening or loosening a lag bolt can change how the door hangs. Overall it’s not too bad but I would’ve use 1/8” plate on the back instead of 1/16”. The guy wanted it light so I went with a lighter plate but 1/8” would’ve worked better. Could’ve been better but it’s not too bad.
- Attachments
-
- 0086562F-FB4B-4719-A833-81EBDD7CD028.jpeg (62.61 KiB) Viewed 560 times
- tungstendipper
-
Weldmonger
-
Posts:
-
Joined:Sun Nov 19, 2017 10:09 am
Looks good! Looks like a lot of fun too!
Lincoln MP 210, Lincoln Square Wave 200,
Everlast 210 EXT
Thermal Dynamics 25 Plasma cutter
" Anything that carries your livelihood wants to be welded so that Thor can’t break it."
CJ737
Everlast 210 EXT
Thermal Dynamics 25 Plasma cutter
" Anything that carries your livelihood wants to be welded so that Thor can’t break it."
CJ737
