[Kuki89]

Hello friends, I have a question as to why the open cornice weld carries less amps than in the flat position and why in the fillet position it carries more amps, why does that happen?

[Toggatug]

Pretty sure it's because a open corner your only melting the edges of the sheet/plate.

Whereas with a butt joint your melting the edge+ a bit into the sheet.

Same with a corner fillet. Simply even more metal mass to heat up.

Least that's what my brain says, I could be wrong feel free to correct me or elaborate on this if I'm on the right track.

Sent from my Pixel 3a using Tapatalk