Can I ask a question right away. I am a beginner welder and have purchased a used 180 sd welder. It worked great for about 6 months but, now it will not put out full amp. I found out that if I set it up to 180 amps it will put out 55amps when the foot pedal is pressed full. Could the trouble be the foot pedal or the control board.
ken
- weldin mike 27
-
Weldmonger
-
Posts:
-
Joined:Fri Apr 01, 2011 10:59 pm
-
Location:Australia; Victoria
Hey mate,
Welcome to the show. I would give miller a ring, they have good tech support.
Welcome to the show. I would give miller a ring, they have good tech support.
- AKweldshop
-
Weldmonger
-
Posts:
-
Joined:Wed Oct 23, 2013 3:30 pm
-
Location:Palmer AK
Sounds like a foot pedal adjustment or something.
Might give miller techs a call(unless they want to charge you)
Or you could ask someone at the Miller forum(I know they don't charge you)
Good luck,
~John
Might give miller techs a call(unless they want to charge you)
Or you could ask someone at the Miller forum(I know they don't charge you)
Good luck,
~John
Just a couple welders and a couple of big hammers and torches.
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
