Does any one use tig AC to weld materials other than aluminium?
If so when/why/settings.
Just curious!
I have on dirty cast iron,with aluminium bronze filler.
Everlast 250EX
Miller 250 syncrowave
Sharp LMV Vertical Mill
Takisawa TSL-800-D Lathe
Coupla Bandsaws,Grinders,surface grinder,tool/cutter grinder
and more stuff than I deserve(Thanks Significant Other)
Miller 250 syncrowave
Sharp LMV Vertical Mill
Takisawa TSL-800-D Lathe
Coupla Bandsaws,Grinders,surface grinder,tool/cutter grinder
and more stuff than I deserve(Thanks Significant Other)
Copper.....crank it up it sucks up the heat.
I weld stainless, stainless and more stainless...Food Industry, sanitary process piping, vessels, whatever is needed, I like to make stuff.
ASME IX, AWS 17.1, D1.1
Instagram #RNHFAB
ASME IX, AWS 17.1, D1.1
Instagram #RNHFAB
I've never heard of this before and I've tried it with no luck.Rick_H wrote:Copper.....crank it up it sucks up the heat.
AC = aluminum and magnesium
You can also do steel with aluminum bronze wire in AC mode
Or a cast steel (If i recall correctly) with aluminum bronze in AC mode
Used deoxidized copper filler, I've heard you can also use silicon bronze. I had the welder at 300amps using a foot pedal, 1/8" tung....it takes a helluva lot more amps then you would expect to get it to puddle.
I had better luck in DCEN on thinner copper
I had better luck in DCEN on thinner copper
I weld stainless, stainless and more stainless...Food Industry, sanitary process piping, vessels, whatever is needed, I like to make stuff.
ASME IX, AWS 17.1, D1.1
Instagram #RNHFAB
ASME IX, AWS 17.1, D1.1
Instagram #RNHFAB