Heat input
Posted: Fri Sep 29, 2017 3:10 pm
Which process puts less heat input in the materiel and why?
Page 1 of 1
Re: Heat input
Posted: Fri Sep 29, 2017 10:14 pm
Not welding anything is by far the clear winner.
Re: Heat input
Posted: Fri Sep 29, 2017 11:32 pm
Cold fusion for the winOscar wrote:Not welding anything is by far the clear winner.
Re: Heat input
Posted: Sat Sep 30, 2017 3:12 am
JB weld is the least heat input I know of !
Re: Heat input
Posted: Sat Sep 30, 2017 8:44 pm
Really which one out of tig, mig, or stick is better for less distortion?
Re: Heat input
Posted: Sat Sep 30, 2017 8:50 pm
The reason these responses cone out is because of very general qiestion that that are missing many important parameters. While heat input can be associated with distortion, joint fixture'ing and geometry has a lot to do with distortion in the finjshed oroduct as well.pfoley wrote:Really which one out of tig, mig, or stick is better for less distortion?
Re: Heat input
Posted: Sat Sep 30, 2017 9:48 pm
As well as material...Oscar wrote: The reason these responses cone out is because of very general qiestion that that are missing many important parameters. While heat input can be associated with distortion, joint fixture'ing and geometry has a lot to do with distortion in the finjshed oroduct as well.
Re: Heat input
Posted: Sat Sep 30, 2017 9:58 pm
Let's say I'm using the same settings for all three processes and the same thickness material?
Re: Heat input
Posted: Sat Sep 30, 2017 11:49 pm
Can't use the same settings for mig, tig, stick...pfoley wrote:Let's say I'm using the same settings for all three processes and the same thickness material?
You will get a lot better responses if you show pics of what you are trying to do.