[James903]

I’ve got a Lincoln 200 square wave. The only torch I have is the one that came with it,and have switched over to gas lenses. I’m looking into trying out some different torches, and not sure which direction to go. I would really like to have one with a remote amp control. The torch I have is a #17 is there a different size I can benefit from? I like trying out things until I find what works for me. I’m just unsure what’s out there and would like opinions from people that have used and more experience then me. Thanks

[Poland308]

What amperage range do you do most of your welding.

[MarkL]

This amp control has gotten really good reviews from a number of people, it's just recently become available for SW200 and I plan to buy one. You might try that instead of buying a torch that comes with one. I've tried two or three amp controls and couldn't get the hang of any of them, it just interfered with keeping my torch steady.

[James903]

My amps are normally between 70-100. All the stuff I’ve been working on I really haven’t had to go any higher then that so far. I have some thicker scrap aluminum I’ve been wanting to practice on, and I will probably turn it up.

Thanks for the info on that controller, I was surprised to see it’s made in Denver, I live about 20 miles away. I might try to contact them and see if I can try it out before I buy. Where did you see the reviews?

[MarkL]

Where did you see the reviews?

The reviews are here on the forum. If you search for the word "tigcontrol" you'll find some of them.