Page 1 of 1

Full cylinder kPa readings

Posted: Tue May 01, 2018 2:56 am
by tonij
Hi everyone,
I just picked up a new G size argon cylinder and thought I'd ask about how to read pressure readings and how to relate it to percentage of gas remaining?
Is there much of a difference in terms of extra gas between 13,000kPa and 30,000kPa because they both are within the full range?
Image

Sent from my SM-G900I using Tapatalk

Re: Full cylinder kPa readings

Posted: Wed May 02, 2018 1:13 am
by Arno
It's pretty much linear, so 13,000kPa (130 bar) it has about 1/2 the amount of gas in the cylinder still compared to for instance 26,000kPa (260 bar)

I don't know what the normal 'full fill' cylinder pressure in Australia is, but here in Europe it's usually either 20,000kPa (200 bar) for most cylinders with a push towards newer 30,000kPa (300 bar) ones.

Move to extra high pressure cylinders is to get additional gas in the same cylinder size or to be able to use a smaller size cylinder (eg. for portability) ans still get the same stored volume as a bigger 200 bar one. (of course needs specific new cylinders and regulators)

Still, a good regulator should be able to work over the whole range and close to it's final outlet pressure while maintaining a steady flow rate so these markings on your gauge are not that interesting. Can be a quick visual indicator it you have many bottles though.

Bye, Arno.