Maxstar 152
Posted: Mon May 03, 2021 10:24 pm
I have a Miller MAxstar 152 tig/stick inverter power source.
HAd it for years , in the early 2000's I bought all of the gear for the tig capability.
I found that the pedal is an on/off switch with no graduation.
I remember back then being told I need another component to have a proper graduated or potentiometer style foot pedal.
There is no gas solenoid either , the torch has a wheel on/off style gas control.
Anyone have any info on the set up of a MAxstar 152 with graduated pedal and gas on/off switch?
Pre -digital.
Thank you.
HAd it for years , in the early 2000's I bought all of the gear for the tig capability.
I found that the pedal is an on/off switch with no graduation.
I remember back then being told I need another component to have a proper graduated or potentiometer style foot pedal.
There is no gas solenoid either , the torch has a wheel on/off style gas control.
Anyone have any info on the set up of a MAxstar 152 with graduated pedal and gas on/off switch?
Pre -digital.
Thank you.