Page 1 of 1

Miller Maxstar 91CC

Posted: Thu Feb 18, 2010 4:19 pm
by lectrician
I picked this welder up at an auction and think it will be useful for the work I do. It had no torch or ground lead with it. I know all torches will not be created equally, but can anyone recommend a middle of the road unit? It also has a foot control and a Snap Start II with it. Does any of this make sense to anyone. I know how to arc, gas and MIG weld. Will I be able to figure this out? Any help will be appreciated. Thanks

Re: Miller Maxstar 91CC

Posted: Thu Mar 18, 2010 1:54 am
by admin
the snap start is the high frequency start unit. without it, you can only stick and scratch start tig.

with that amperage , i would get a #9 size air cooled torch from tectorch or weldcraft.

thanks,

jody