Page 1 of 1
Tie Ins ???
Posted: Sun Aug 26, 2012 5:05 pm
by rahtreelimbs
What is the proper way to handle ties on carbon, stainless and aluminum???
I am guessing it may vary on what is being welded???
Re: Tie Ins ???
Posted: Thu Aug 30, 2012 9:14 pm
by Otto Nobedder
Ahh. This is what you asked about.
How you handle tie-ins depends on the quality required of the weld. In any critical weld, you'll grind (sorry--your helper will grind) your tacks down to a knife-edge at each end, for complete fusion during the root. I (my helper) usually uses a .045 cut-off wheel for this.
Steve S.