More Fillets, Thin Material
Posted: Thu Mar 21, 2013 3:06 pm
Day two. My girlfriend works for Lowes and got these alum extrusions on clearance. She thought I might enjoy playing with them.
The material is 3/32 5051 sheet and alum channel extrusion alloy unknown, rod is 3/32 4043, 3/32 2% Lanthinated, Everlast 250EX with cooler, 114 amps, a/c 165 hz, balance 30% EP, 500 hz pulse, 45% on-time, 50% background.
The material is 3/32 5051 sheet and alum channel extrusion alloy unknown, rod is 3/32 4043, 3/32 2% Lanthinated, Everlast 250EX with cooler, 114 amps, a/c 165 hz, balance 30% EP, 500 hz pulse, 45% on-time, 50% background.
- First run. Lost it a little in the edge control, but seeing improvement.
- DSCN4640.JPG (127.89 KiB) Viewed 421 times
- Same run, different angle.
- DSCN4645.JPG (123.98 KiB) Viewed 421 times
- Same run, 500 hz pulsing and 165 hz A/C helps preserve the edge on the tail end.
- DSCN4643.JPG (123.13 KiB) Viewed 421 times