Page 1 of 1

Re: Arc Pig

Posted: Thu Jun 13, 2013 6:14 pm
by Otto Nobedder
Nick, I tried to delete the duplicate topic, and wiped out both of them, somehow.

Sorry about that... Please repost if you wish.

I'll have a look at arcpig.com, and comment on what I find.

Steve S

Re: Arc Pig

Posted: Thu Jun 13, 2013 6:21 pm
by Otto Nobedder
Yep, that's a great way to do it.

HF start should be a no-brainer. I'll have to read a little deeper on the HFAC welding, as I've never done HFAC above 400Hz, and a "simple" tesla coil can easily be in the KHz range and above. (Think radio interference).

This is just from a "glance" at the page, though. I need to read a bit more.

Steve S

Re: Arc Pig

Posted: Thu Jun 13, 2013 6:40 pm
by Otto Nobedder
All right, then.

It's a Tesla-coil based arc-starter only, and will not perform an HFAC function for welding aluminum with a DC machine.

It will auto-start DC, and AC, 60, 120, up to 240Hz (and anywhere in between).

That's crazy that it works with stick... Might save a LOT of headache for stick newbies.

Haven't looked at pricing yet, but since they say it'll work with cheap-o Harbor Freight stuff, I'm assuming it's reasonable.

And, whoever answered the FAQ's has a fine sense of humor.

Steve S

Re: Arc Pig

Posted: Thu Jun 13, 2013 9:05 pm
by nickn372
$495 for the base unit which is really all you need except for the torch itself and maybe some tweco twist locks.