Page 1 of 1

TUGSTEN PREP!

Posted: Mon Jul 01, 2013 4:09 pm
by cacinni
Will be welding 1/4" carbon steel round stock mesh strainer basket for weld test, round stock to round stock, long taper the end for small arc and puddle, should i blunt the end or leave to a point? Advice guys! THANK YOU!

Re: TUGSTEN PREP!

Posted: Mon Jul 01, 2013 7:59 pm
by Otto Nobedder
For anything but aluminum, you should be able to "tattoo" with the tungsten. The crisper the point, the more control you have over where the arc goes.

Steve S