Page 1 of 1
flow meter setting for using a gas lense
Posted: Wed Oct 16, 2013 6:45 am
by c.v.fabrications
hi, after using a normal collet and collet body in my wp9 tig touch for awhile with my flow meter set at about 5 to 6 litres per minute i decided to get a gas lens and a no7 gas lens cup of the internet, can someone please help out.
thanks
Re: flow meter setting for using a gas lense
Posted: Wed Oct 16, 2013 2:06 pm
by noddybrian
Hi - if you have added the gas lens for extra cover on a long stick out I'd keep the flow rate the same ( though it's on the low side depending on position of weld / amps / material & stillness of air ) but if welding with a conservative stick out you can normally drop flow rate about 30% - in view of how low your running at the moment I probably would'nt though.