Hi, I have a Miller Syncrowave AC/DC that has been welding perfectly. Recently it decided to stop welding. Code 5 came up later 10 then back to 5. In between it works perfectly then cuts out again gong to code fault 5. It has never overheated and each use is short so no possible way to overheat the rectifier. Fans run and water cooling is fine. I am running single phase 240 volts.Any thoughts?
Many thanks, Deusy. Frank United Kingdom.
- Otto Nobedder
-
Weldmonger
-
Posts:
-
Joined:Thu Jan 06, 2011 11:40 pm
-
Location:Near New Orleans
I don't recall those fault codes off the top of my head. I'll try to remember to check the manual tomorrow at work.
Steve S
Steve S
- weldin mike 27
-
Weldmonger
-
Posts:
-
Joined:Fri Apr 01, 2011 10:59 pm
-
Location:Australia; Victoria
Hey mate,
Send an email to miller tech support. I hear they are top notch.
Mick
Send an email to miller tech support. I hear they are top notch.
Mick