Hi,
I found some older rod, aluminum, stainless, and brass. All of them have some dirt, rust contamination and general crap on them. What is the best way to clean them up, or are they no good?
Thanks in advance,
Buggsy
- weldin mike 27
-
Weldmonger
-
Posts:
-
Joined:Fri Apr 01, 2011 10:59 pm
-
Location:Australia; Victoria
Scotch bright and acetone. Happy times.
- TRACKRANGER
-
Weldmonger
-
Posts:
-
Joined:Wed Aug 06, 2014 12:48 am
-
Location:Melbourne, Australia
Probably the brass you mentioned is actually bronze
Like Mike mentioned, scotch bright - but you could also probably also use emery paper if the contamination is severe. Stainless Steel Wool is also great for the aluminum.
Like Mike mentioned, scotch bright - but you could also probably also use emery paper if the contamination is severe. Stainless Steel Wool is also great for the aluminum.
EWM Phonenix 355 Pulse MIG set mainly for Aluminum, CIGWeld 300Amp AC/DC TIG, TRANSMIG S3C 300 Amp MIG, etc, etc