Welding Tips and Tricks

Friends
Am trying to get certify for bearing welding but specification cracks comming.Am new for this welding....
parameters using
Miller syncrowave
Amps 230 to 250amps
Post flow time 9 sec
Plate is low carbon for testing 10mm thick
It is not straight LINE welding.that plate has 3 holes 0.22 inches.in that holes 0.22 inch pin has to place and weld for certification.welding around 6 seconds

Welcome to the forum.

Hi thank you.

Rajasekar wrote:Friends
Am trying to get certify for bearing welding but specification cracks comming.Am new for this welding....
parameters using
Miller syncrowave
Amps 230 to 250amps
Post flow time 9 sec
Plate is low carbon for testing 10mm thick
It is not straight LINE welding.that plate has 3 holes 0.22 inches.in that holes 0.22 inch pin has to place and weld for certification.welding around 6 seconds

Hi
Thanks for the request and the detail you already sent

Any chance you can send a photo of the item being welded?

(PS: Welcome also to the Forum)
Trevor