![Idea :idea:](./images/smilies/icon_idea.gif)
I made a machine settings chart and want to see if others find this useful in setting up their machine. I intend to start using a chart like this on WPSs that I write for small fab shops that are AISC certified. I usually train the welders in these shops and haven't had any troubles with audits, but...these auditors are getting smarter and are being trained better and I don't want them to trip up any of the welders using my WPSs. I need others to try several of the voltage/amperage settings and also notice if the WFS is somewhere close to being correct or not.
A general rule for measuring the WFS is to squeeze off 6 seconds of wire and measure the length, then add a zero(essentially multiplying by ten)...ie 6 secs produces 14" of wire = 140ipm
Try it at the low end, the high end and a couple places in between and let me know what you think. I took these directly from Lincoln's data sheets and added a few points along the way to get from the low to the high end.
Thanks in advance to any who try this for me.
![Wink ;)](./images/smilies/icon_e_wink.gif)
![Geek :geek:](./images/smilies/icon_e_geek.gif)