Page 1 of 1
angle iron to square tube
Posted: Sat Mar 03, 2018 5:59 pm
by Bellaireroad
On these fillet welds, is it best to start in the middle and work out or start on the outside and work in? Or do you just make one continuous weld? Or does it make any difference?
Sent from my iPhone using Tapatalk Pro
Re: angle iron to square tube
Posted: Sun Mar 04, 2018 9:16 pm
by 5th Street Fab
Bellaireroad wrote:On these fillet welds, is it best to start in the middle and work out or start on the outside and work in? Or do you just make one continuous weld? Or does it make any difference?
Sent from my iPhone using Tapatalk Pro
The center is the thickest part so it'd be better not to start there. I usually weld from one end to the other.
Sent from my XT1635-01 using Tapatalk
Re: angle iron to square tube
Posted: Mon Mar 12, 2018 10:51 pm
by Bellaireroad
Thanks
Sent from my iPhone using Tapatalk Pro