too much weld
Posted: Fri Dec 28, 2018 4:06 pm
thanks in advance -
I have miller211 - flux core 030 - and too much weld material - I have used the chart but just am not happy with product -
3 things to adjust - speed of hand, Amperage, wire feed speed -
I have gone up and done the dial and this new rig is frustrating - older Lincoln rig with 030 flux - stacked dimes nicely - experience level is moderate to making a living with sticks -
I run it off trailered 225 bobcat in 120v setup - dcen - but in the end I am spending way too much time trying to get the "sizzle" dialed in.... help thanks
I have miller211 - flux core 030 - and too much weld material - I have used the chart but just am not happy with product -
3 things to adjust - speed of hand, Amperage, wire feed speed -
I have gone up and done the dial and this new rig is frustrating - older Lincoln rig with 030 flux - stacked dimes nicely - experience level is moderate to making a living with sticks -
I run it off trailered 225 bobcat in 120v setup - dcen - but in the end I am spending way too much time trying to get the "sizzle" dialed in.... help thanks