SpinArc??
Posted: Fri Dec 18, 2015 4:00 pm
Found an interesting new welding process from youtube.
Anyone tested yet?
lQ_t47hW2Rg
Anyone tested yet?
lQ_t47hW2Rg
Page 1 of 1
Re: SpinArc??
Posted: Sat Dec 19, 2015 12:30 pm
I had not heard of that...looks interesting, seems like decent penetration since your oscillating the puddle...fast too!
Re: SpinArc??
Posted: Sat Dec 19, 2015 12:53 pm
Yep really fast! 
Also good amount of build up in single weld.
Perhaps process is more to robotic welding.
They were at Fabtec. JODY!!! Did you visit at their boot?
Also good amount of build up in single weld. Perhaps process is more to robotic welding.
They were at Fabtec. JODY!!! Did you visit at their boot?
Re: SpinArc??
Posted: Sun Dec 20, 2015 12:46 am
They are coming in January for me to test it out. When that happens I'll report back here for sure. I'm hoping this process will cut down on our weld time on large weldments.
-Jonathan
-Jonathan
Re: SpinArc??
Posted: Fri Feb 05, 2016 4:15 am
Superiorwelding wrote:They are coming in January for me to test it out. When that happens I'll report back here for sure. I'm hoping this process will cut down on our weld time on large weldments.
-Jonathan
Did they visit you?
Re: SpinArc??
Posted: Fri Feb 05, 2016 9:31 am
No they didn't. I actually just sent a email as to what happened. I will report back when I hear anything. I already had the 3" plate prepped and ready for them too...
-Jonathan
-Jonathan
Re: SpinArc??
Posted: Sun Feb 21, 2016 4:41 pm
Anything happened yet??
Re: SpinArc??
Posted: Tue Feb 23, 2016 6:45 pm
Nothing. I have about given up on them. Lol.
Re: SpinArc??
Posted: Thu Feb 25, 2016 2:00 am
What
Very "promising" product
Very "promising" product